A simply stunning preamp. Not only does it draw less power while running than most others use while off, it's renown as one of the cleanest, most transparent preamps. Ever.
Production
1971-77
Condition
8/10
Serial No.
IC539E
Orig. MSRP
$269 (add $33 walnut cabinet)
Restoration
- Full 30-point service check
- Cleaned controls, switches, and chassis
Specs
Frequency response 3Hz to 100kHz
Total harmonic distortion 0.01%
Gain 50dB (MM), 20.8dB (line)
Signal to noise ratio 80dB (MM), 90dB (line)
Inputs Five line-level inputs (one tuner, two aux, two tape); Two equalized phono inputs
Input Gain & Impedance 20.8bB ± 0.2dB, 100KΩ (Line); 50-70dB adjustable, 47KΩ (Phono)
Sensitivity 1mV @ 1KHz for rated output
Line Out Main 1, Main 2, Tape 1, Tape 2
Output 2.5V (Pre out)
Semiconductors 2 x IC, 12 x transistors, 1 x FET, 3 x zener diodes, 7 x diodes
Dimensions 17"W x 5.25"H x 8.25"D
Weight 10 lbs., 16 lbs. with walnut cabinet
Documentation
Crown IC150 Service Manual
The History of Crown
In 1947 an Elkhart, Indiana minister named Clarence C. Moore founded the International Radio and Electronics Corporation (IREC) which, over the years, has become better known as Crown Audio Inc. Moore started by building open-reel tape recorders out of a chicken coop but today, Crown Audio is an industry leader in...
[ Read More ]
Liner Notes
The Crown IC 150 was a state-of-the-art preamplifier when it came out in 1971. It offered an unheard of level transparency due to its ultra-low noise levels. This was a top-quality preamplifier, American-made to commercial standards, listing for the equivalent of over $1,500 when new. The separate phono preamp board, mounted right at the phono input connectors, has several discrete transistors. It's also a gem, using 1% resistors and 2.5% capacitors for precise adherence to the RIAA curve. It also has rear-panel adjustable gain for each channel from 30 ~ 50 dB so your turntable's level and balance can match your other components.
-Ken Rockwell
Packing
Prepare to be impressed. We have arguably the best packing process around. This piece will ship double-boxed, and fully insulated, taking extra care to ensure there's no pressure against the face. First, the component is first wrapped in 8mil plastic. Then, the unit is strapped to a plate inside an inner box to prevent shifting, and padded on all sides. We then suspend the inner box inside a double-walled outer box using shock-resistant foam corners.
Shipping
This piece ships to the contiguous United States for a flat rate of $150, which includes our packaging and our insurance. Of course, we'll ship anywhere in the world, just drop us a line and we'll give you an estimate – even if you're just curious.
Stock No.
7589425610973
